How To Finish Top Stair Tread With Laminate Flooring

Most often the top stair will involve installing a stair nose.

How to finish top stair tread with laminate flooring.

Now if carpeting is used for the second floor i rip off the 1 4 of the width that has the groove and use sandpaper to kiss the edge to take the sharp edge off. In banister applications it is the board on the floor and balusters and posts are installed on top. For the tread you may need to place the laminate plank on top of the stair to get an exact fit. How to installing laminate flooring on stairs you can face with stair landing installation.

Landing tread is a type of stair part that is used either under a floor level banister as shoe rail or around an intermediate landing of a stairway. Next you can cut the riser pieces similarly. Or you can have laminate on the stairs and need to finish the carpet up to the top stair of laminate. The only difference here is that the riser is vertical.

The new stair nose cannot be installed with an overhang. The hardwood flooring guy handles it from the top of stair run. The risers go on next. With the addition of a laminated stair nose it rivals all other materials for wear durability and appearance.

A coat of stain if desired wiped on and off and allowed to dry can be covered with a coat of. How to finish stairs with laminate. It creates a border between the finish flooring and the balustrade itself. Once you ve installed the rest of the stairs cover the top tread and install a transition to finish the flooring at the top of the stairs.

With the laminate being lower than the top stair its not a good idea to use a t mold as it would be on a slant. I m assuming the top stair is 3 4 of an inch thick. Most of the stairs have an overhang that may need to be cut off. If one plank doesn t suffice you may have to cut and join another one.

Before installing laminate flooring on stairs you shouldn t finis. Laminate floor planks work well on stairs. The riser must come flush with the surface of the tread and the stair nose which goes on last curls around the top of the riser and either fits flush against the laminate. I would use a square edge transition and butt the vertical edge of the transition up against the top stair.

Scraped and sanded oak stair treads are comparatively simple to finish. The international building code specifies a maximum riser height of 7 inches so a single laminate plank usually suffices but you may prefer to use pine poplar or some other stainable wood instead. Place the plank against the riser for a better measurement.