How To Get Linoleum Glue Off Hardwood Floors

If you re removing linoleum from hardwood floors consider heating the linoleum with a heat gun first instead of just peeling it off while it s at room temperature.

How to get linoleum glue off hardwood floors.

It was a lot of hard work but seemed to minimize damage to the floors and the amount of sanding required. Place a pot with 4 6 cups of water on the stove and wait for it to boil. Once the adhesive is loose use a floor scraper to remove as much of it as you can. You could also use an electric kettle to bring your water to a boiling point step 2 soak towels in the hot water.

Insert the edge of the floor scraper beneath the one of the cut marks in the linoleum. This keeps the hot water contained and allows it to rest. There are chemical adhesive solvents on the market but my concern is that they would soak into the hardwood. I would try working on small areas at a time by pouring boiling water on the adhesive and letting it sit for about ten minutes.

Push forward with the scraper in short thrusts to bring up the top layer of the linoleum. There are lots of ways to get glue and adhesive off the floor from diy methods to rented machines. Wait for at least ten minutes to let the adhesive freeze. Working in sections apply heat to soften the bottom.

A heat gun softens the glue which makes it easier to remove the linoleum and the glue. If it s a beautiful hardwood floor consider sanding the glue adhesive from the wood floor to keep it in the best condition possible. If you apply harsh chemicals or spend time scraping at the glue it may damage the wood flooring. Saturate an old towel with plain water hot water is sometimes even more effective so try heating the towel in the microwave first and lay it on the floor for twenty minutes.

Then use a scraper to break the glue apart and lift it off the wood. Use old towels that are already stained or dingy but still clean. If the adhesive was water based the warm water will loosen or soften it and make it easier to scrape. Some of the adhesive.

Remove the top layer of flooring material with a scraper or oscillating tool. Just score the hard top layer of linoleum to pull it off in strips then score and steam the felt paper glue tar paper and more glue. Step 1 bring a pot of water to a boil. Be careful not to scald your hands 1 x research sourcestep 3 place the wet towels on the floor.

Place chunks of dry ice in a shallow pan and place the container on top of the glue patch.