Hot glue another strip about 1 2 to 1 depending on how dense you want the fringe to be above the last.
How to hang a rug with fringe on the wall.
Pass a bar through the strip and hang the rug.
Cut a piece of fabric the same width of your rug large enough to be able to form a tube that will snuggly fit the width of your rod.
Insert a suitable rod.
Line up the carpet tack strips where you ll want to hang the rug and gently hammer the nails into the wall.
Next stretch it out left and right and place additional push pins there.
Hanging heavy weight rugs.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
This method allows you to hang a fringed rug on the wall without damaging it.
This should be attached close to the top of the rug.
To protect your rug from the wood and nails paint or seal the rug strip and let it dry completely.
The second method of hanging an area rug on the wall involves the use of a curtain rod.
To hang a round rug on the wall you would use push pins or command strips.
Then pin the bottom.
For extra support hammer nails into the corners.
Hanging fringed rug on wall hanging fringed rug on wall.
The second method of hanging a rug should be used for large and heavy weight rugs.
A heavy cotton casing may be sewn onto the back of the rug again this should be hand sewn if hanging a handmade or antique rug to form a tube through which the curtain rod may be inserted.
Attach rod support the brackets to the wall aligned with the gaps in the.
Insert rod into the tube of fabric on the rug and hang the rod onto the wall.
Sew muslin to the top of the rug.
Now add your contrasting fringe.
Attach the tape to the back of the rug in the same way as for a smaller rug.
Put the top of the rug there and put a push pin or command strip there.
Using a level to ensure the strip is entirely straight attach the piece to the wall using nails or screws.
Hot glue a strip of the cotton fringe right along the long bottom edge of your rug.
Attach anchors to the wall using a drill and screws.
This will serve as casing for your rod when hanging the rug.
First cut the tape into 12 inch sections and attach the sections to the rug 1 2 inch apart.
Knot a decorative c.
Since you ve already measured your carpet tacks to the length of your rug you ll want to place the strip where the top of the rug will sit on your wall.
These gaps permit the use of additional brackets and prevent sagging.
Lift the rug and press it into the strap to attach it.
Hanging fringed rug on wall.
First mark where you want the rug.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
Cut a few small strips and lay them on top to decide where you want them.
