How To Install Metal Edging For Ceramic Tile

Metal tile edging consists of rigid metal strips that are shaped like an l they fit under the edge of metal tiles to create a continuous finished edge along the side of the installation area.

How to install metal edging for ceramic tile.

We re here to make it easy. This rounded edge gently curves into the wall or counter it is installed on finishing the edge of the ceramic tile installation. Installing tiles in the corners of the metal edging is not difficult if you take good measurements. Use a market and and l square to draw the cut lines.

A tile trim is easy to install and not only reduces how long it will take to lay your tiles it also protects the edges of your niche and completes the look. Cutting tile with a wet saw. Although metal edging is typically used with metal tiles it can also be used with ceramic tile. If the metal is horizontal or vertical use flexbond fortified thin set mortar as an adhesive.

Most lines of ceramic tiles include bullnose tile options. Use a market and and l square to draw the cut lines. Edge tiles with metal trim for a contemporary finish. They are a great way to transition between tiled and non tiled surfaces.

You can use them on all sorts of tiled surfaces including counters showers floors walls and stairs. Installing ceramic tile on metal is just as easy as installing ceramic tile on concrete. Work with care and attention to draw accurate marks on a tile. After installing a tile niche it s important to make sure the edges and the corners have a professional finish rather than leaving an exposed tile edge which can be easily damaged.

A tile trim is easy to install protects the edges of your niche and completes the look. Work with care and attention to draw accurate marks on a tile. Installing tiles in the corners of the metal edging is not difficult if you take good measurements. Finishing pieces can make a huge impact on the overall design of your tile and we want to ensure our clients love their tile from beginning to end.

The substrate is hard and rigid so there is no need to use concrete backer board. Choosing tile is hard enough and the nitty gritty details of trim can be overwhelming. We recommend you to use a wet saw to make complex cuts like the one in our project. Flexbond will work well in either situation.