Place the anchor screw in the pilot hole.
How to install shutter anchors through tile floor.
Finish installing the screw with a screwdriver until it is flush.
An alternative to drilling into your tile is to use a tensioned shower curtain rod.
Repeat for other shutters.
The anchor screw should be the same size as the screw you will be using.
Drive 3 inch screws through the wood and into the tile to anchor the wood frame to the floor.
8 set the cabinets on the wooden frame and align flush with the framing lumber.
5 keep the drill cool while drilling through the tile by dipping it into water frequently.
The anchor will be flush with the tile once fully inserted.
Insert the screw into the anchor and twist a few times so it will stay.
This type of rod has rubber ends and keeps in place through the friction generated through spring.
Use a hammer to gently tap the fasteners to snug the shutter to the siding.
A correct rod placement is when your curtain rests just above the floor or so that when the shower is running all of the water is contained in the shower area.
Push shutter locks through the holes in the shutter and into the hole in the wall surface.
A smaller or larger anchor screw will simply cause the screw to either break the tile or fall from the anchor.
Typical drive in plastic anchors require a 1 4 or 5 16 inch 0 6 or 0 8 cm hole molly anchors and other expansion anchors may require larger holes to allow them to expand properly.